高温条件下高速碰撞试验技术研究

目的建立高温条件下结构的高速碰撞试验技术。方法基于理论和试验方法,研究影响试样加热/保温、碰靶速度和姿态的关键因素,利用次口径发射技术和电炉技术实现试样的加热、保温和加速。采用间接方法测试试样碰靶时的温度,联合应用次口径发射技术和靶体,控制试样的碰靶姿态,并利用高速摄影技术对其进行测试。通过薄壁圆柱筒的高温高速碰靶验证高温试验技术的有效性。结果建立了加热、加速和姿态控制一体化的高温高速碰撞试验技术,获得了不同尺寸薄壁圆柱筒不同姿态碰靶时的高温冲击动力学响应。正碰时,撞击端镦粗,尾端收缩,尾端的凹陷大于碰撞端的变形;侧碰时,圆筒呈马鞍状;角碰时的变形为楔形。随着圆筒的强度和刚度的降低,圆筒的变形增加,整体发生坍塌,出现大量的皱褶。结论建立的试验技术切实有效,可以用于高温条件下结构高速碰撞效应的研究。     

环境升温过程对常温固化环氧树脂热力学性能的影响

目的提高常温固化环氧树脂体系的高温使用性能。方法采用常温固化剂T31、中温固化剂IPDA以及高温固化剂DDM作为混合固化剂,对E-44型和AG-80型混合环氧树脂体系进行常温固化反应,并分析环境升温过程对固化物热力学性能的影响。通过DMA分析、热变形测量、固化度测试,分别评价室温固化环氧树脂在环境升温过程前后的玻璃化转变温度、热变形量及体系内部的固化反应程度变化,并通过吸水率测试和弯曲强度测试对玻璃纤维布增强常温固化环氧树脂基复合材料的耐湿热性能以及高温条件下的力学性能进行分析。结果环氧树脂常温固化物的tg为85.21℃,经1.5℃/min的平均升温速率加热至90℃之后,该环境升温过程使固化物的固化度增大至92%以上,tg增长为132.06℃的同时热变形温度增大。其复合材料耐湿热性能提高,且100℃时弯曲强度的保持率为65%,对于加热至120℃的环境升温过程,固化物的固化度接近96%,tg增长为144.45℃的同时热变形温度进一步提高,其复合材料耐湿热性能改善程度更加明显,且130℃时弯曲强度保持率仍接近60%。结论常温、中温、高温混合固化剂的合理复配有助于环氧树脂体系在环境升温变化的诱导条件下发生梯度式固化反应,使体系内部的交联固化程度迅速升至较高水平,可以有效提高其玻璃化转变温度,显著改善常温固化环氧树脂体系在高温条件下的热力学性能。     

Laboratory and Field Assessment of Arsenic Testing Field Kits in Bangladesh and West Bengal, India

High concentrations of arsenic in ground waters in West Bengal and Bangladeshhave become a major cause for concern in recent years. Given the enormity and the severity of the problemof arsenic poisoning, a task of evaluating the commercially available arsenic detection field kits for their capabilities was undertaken. In the light of the findings, generic specificationswere recommended which could form the basis forindigenous manufacture of these kits in the arsenic affected countries. This article presents the results of the laboratory and fieldevaluation conducted in Bangladesh and West Bengalof five arsenic testing field kits. The salient features of the kits, their merits and limitationshave been brought out. Based on the criteria of kitdesign, quality of chemicals used, colourcomparator charts, detection range, time required for analysis, cost etc., a comparative ranking ofthe kits has been made to facilitate the choice of the kit to meet specific requirements.     

纳米TiO2/CNTs复合材料的制备及其光学性质

TiO2在碳纳米管上的复合材料可以增加材料的光催化性能,已成为新的研究热点.本文采用低温液相法成功地合成了TiO2/CNTs复合材料,并用TEM、XRD和UV-vis对材料进行了表征,结果表明,TiO2很好地分散在CNTs上,具有显著的催化效果,有很好的应用前景.     

干旱区2种猪毛菜萌发过程对水盐胁迫的生态响应

在实验室内模拟研究的基础上,运用生理生态学的原理,研究了水盐胁迫对钠猪毛菜(salsola nitraria)和散枝猪毛菜(salsola brachiata)种子萌发的影响,结果显示,钠猪毛菜与散枝猪毛菜种子萌发的最适温度分别为25 ℃和15 ℃.在盐溶液和PEG溶液中,2种种子的萌发规律相似,即随着水势的降低,萌发率和萌发速率下降.在盐胁迫下钠猪毛菜和散枝猪毛菜种子萌发的最低水势接近-7.2 MPa;在水分胁迫下2种种子萌发的最低水势均未超过-2.0 MPa,其中,钠猪毛菜种子表现出较强的耐水分胁迫能力.在相同水势条件下,PEG对2种猪毛菜种子萌发的抑制程度显著大于等渗NaCl,说明渗透胁迫是影响2种植物种子萌发的主要因素.     

The importance of temperature in assessing iron pipe corrosion in water distribution systems

Temperature is expected to play a significant role in the corrosion of iron pipes in drinking water distribution systems. Temperature impacts many parameters that are critical to pipe corrosion including biological activity, physical properties of the solution, thermodynamic and physical properties of corrosion scale, and chemical rates. Moreover, variations in temperature and temperature gradients may give rise to new corrosion phenomena worthy of consideration by water treatment personnel.     

A study on the orbit of air temperature movement

In this paper, we describe an air temperature movement by mapping its time series to the polar coordinates: the value of the time series is plotted on the radial coordinate and the time on the angular coordinate. In this way, both the yearly and daily air temperature movements from five different locations of China are used to demonstrate that, in an intuitionistic view, air temperature movement is neither random nor chaotic, but has its own orbit. We then propose an elliptic orbit model for the air temperature movement. Our proposed model provides quite good results when it is applied to the evaluation of yearly air temperature movements in eight locations in various parts of the world, and the evaluation of daily air temperature movements in five locations in Hunan Province of China on December 17, 2005. Results show that our approach provides a concise and helpful model for air temperature analysis.     

Effect of temperature on single and competitive adsorptions of Cu(II) and Zn(II) onto natural clays

This study conducted a combined adsorption-sequential extractionanalysis (CASA), by which five phases (i.e., exchangeable, carbonate, Mn-Oxide, organic, and Fe-Oxide phases) of adsorbed heavy metals were analyzed, to investigate temperature effects on single and competitive adsorptions of Zn(II) and Cu(II) ontonatural clays. In the case of single adsorption of Zn, the exchangeable phase adsorption decreased from 65 to 40%, but thecarbonate phase adsorption increased from 30 to 40%, with an increase in temperature from 15 to 55 °C. However, in itscompetitive adsorption with Cu, Zn was mostly present in the exchangeable phase (over 90%), and with an increase in temperature, the exchangeable phase adsorption decreased only 10%. In the case of Cu, over 50% among the total amount of adsorption was present in the carbonate phase in both cases ofsingle and competitive adsorptions. The carbonate phaseadsorption of Cu increased from 56 to 61% and from 60 to 66% in single and competitive adsorptions, respectively, with atemperature increase. These results show that in the case of Zn,the major mechanism of retention in natural clay soils might beexchangeable phase adsorption, especially in the case of competitive adsorption with Cu. However, in the case of Cu, the major mechanism might be carbonate phase adsorption, which is known to be a more immobile phase than exchangeable phase adsorption. It seems that the adsorption of Zn and Cu onto natural clays is an endothermic reaction, which represents thatthe adsorption equilibrium constants and capacities increase with a temperature increase, with the exception of exchangeablephase adsorption.     

Integrated nutrient management and waste recycling for restoring soil fertility and productivity in Japanese mint and mustard sequence in Uttar Pradesh, India

Supplementing the nutrient requirement of crops through organic manures plays a key role in sustaining soil fertility, and crop productivity and reducing use of fossil fuels. Field experiments were conducted for 2 years at two different locations (i.e. Lucknow and Pantnagar) in Uttar Pradesh, India. The objectives of the study were to assess the herb and essential oil yields of Japanese mint (Mentha arvensis cv. Hy 77), and its nutrient accumulation under single and combined applications of organic manures and inorganic fertilizers (NPK). Changes in physical and chemical characteristics of the soils (Fluvisols, Mollisols) were also determined. Eight treatments comprising different combinations of NPK through inorganic fertilizers and farm yard manure (FYM) were compared. The distilled waste of mint after extraction of essential oil was recycled to soils in the plots to supplement the nutritional requirement of the succeeding mustard crop (Brassica juncea cv. Pusa Bold). Herb and essential oil yield of mint were significantly higher with combined application of organic and inorganic sources of nutrients as compared to single applications. Accumulation of N and P was at par under full inorganic and combined supply whereas, K accumulation was higher with the former. Soil organic C and pH after harvest of mint did not significantly differ among the treatments, but the level of mineralizable N, Olsen-P and NH₄OAc extractable K were higher in soil with integrated supply of nutrients. Significant increase in soil water stable aggregates, organic C, available NPK and microbial biomass, and decrease in soil bulk density were observed with waste recycling over fertilizer application. These benefits were reflected in the seed and stubble yield of mustard which succeeded mint. This study indicates that combined application of inorganic fertilizers with organics helps in increasing the availability of nutrients and crop yield and provides a significant effect to the succeeding crop. Similarly, recycling crop residues reduces the need for fossil fuel based fertilizer, and helps in sustaining and restoring soil fertility in terms of available nutrients and major physical and chemical characteristics of the soil.     

华北山区温度推算模式和应用

利用华北山区气象站观测的温度与其所在纬度、经度和高度，分山区建立宏观地面气温场方程。采用１：２０万地形图，以１０＇经、纬度为步长，判读其高度值，代入已建立好的方程中，经地形项订正，推算华北山区年、月平均温度、年较差和ΣＴ＇≥１０℃，其精度达极显著水平。计算结果使我们对华北山区热量资源有了新的认识，最后求算华北山区的主要水果最优品质种植上限高度。